MSDS

Date Printed: 5/7/2015
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Acetone 67-64-1 25.0 500 ppm 750 ppm 1000 ppm N.E.
Propane 74-98-6 20.0 1000 ppm N.E. 1000 ppm N.E.
Medium Oil Alkyd Proprietary 10.0 N.E. N.E. N.E. N.E.
n-Butane 106-97-8 10.0 1000 ppm 1000 ppm N.E. N.E.
Xylene (mixed isomers) 1330-20-7 10.0 100 ppm 150 ppm 100 ppm N.E.
Hydrous Magnesium Silicate 14807-96-6 10.0
2 mg/m3
(Respirable
Dust)
N.E.
20 mppcf
(Mineral Dust
<1% Quartz)
N.E.
Mineral Spirits 64742-88-7 10.0 100 ppm N.E. 100 ppm N.E.
Limestone 1317-65-3 10.0
15 mg/m3 (Total
Dust, OSHA)
N.E.
5 mg/m3
(Respirable Dust)
N.E.
n-Butyl Acetate 123-86-4 5.0 150 ppm 200 ppm 150 ppm N.E.
Iron Oxide 1309-37-1 5.0
5 mg/m3
(Respirable
Dust, OSHA)
N.E.
15 mg/m3 (Total
Dust)
N.E.
Ethylbenzene 100-41-4 5.0 20 ppm 125 ppm 100 ppm N.E.
Barium Sulfate 7727-43-7 5.0
5 mg/m3
(Inhlalable
fraction w/o
asbestos and
<1% cryst.silica)
N.E.
15 mg/m3 [Total
Dust]
N.E.
Zinc Phosphate 7779-90-0 5.0 N.E. N.E. N.E. N.E.
Titanium Dioxide 13463-67-7 1.0
10 mg/m3 (Total
Dust)
N.E.
15 mg/m3 [Total
Dust]
N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use explosion-proof ventilation equipment. Provide general dilution of local exhaust ventilation in
volume and pattern to keep TLV of hazardous ingredients below acceptable limits. Prevent build-up of vapors by opening all doors
and windows to achieve cross-ventilation. Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with organic
vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to exceed
exposure limits.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
9. Physical and Chemical Properties
Appearance:
Aerosolized Mist
Physical State:
Liquid
Odor:
Solvent Like
Odor Threshold:
N.E.
Relative Density:
0.845
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Slight
Partition Coefficient, n-octanol/
water:
No Information
Decompostion Temp., °C:
No Information
Boiling Range, °C:
-11 - 999
Explosive Limits, vol%:
0.7 - 13.0
Flammability:
Does not Support Combustion
Flash Point, °C:
>94
Evaporation Rate:
Faster than Ether
Auto-ignition Temp., °C:
No Information
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
Page 4 / 8