Installation manual

8 Russound In-wall LCR Loudspeaker Installation Manual
INSTALLATION
Installation
Remove the grille and bae from the speaker, if applicable. Use the clamp 1.
(dog-ear) to push the grille out from the back side.
Center the frame in the cutout. Tighten the screws equally until the clamps 2.
secure the frame. Do not overtighten.
Connect the speaker wire to the speaker terminals:3.
Leave about 1' (30.5 cm) of wire extending through the cutout.•
Pull the conductors apart so the last two inches are separated and •
remove ½" (1.3 cm) of insulation from the end of each conductor.
Twist the strands in each conductor into tight spirals.•
Attach the speaker wires to the red and black speaker terminals. Connect •
the Positive (+) conductor to the Red terminal and the Negative (-)
conductor to the Black terminal. Make sure that no stray strands of wire
are touching the other conductor or terminal.
The speakers have a plug (the Russound Logo) that can be removed for 4.
placement of an remote IR receiver (Russound 862 Eye). See detail below.
Insertion of speaker wire on back of speaker bae
+

Install Speaker Frame
As screws are tightened
clamp will rotate out and
snug against the drywall.
Cutout
Screws
Speaker Cable
Frame
IR Receiver Installation
Treble
IR Receiver
Plug
Bae