Installation manual

11
Russound In-wall LCR Loudspeaker Installation Manual
TROUBLESHOOTING GUIDE
Troubleshooting Guide
Before returning your Russound speakers for service, try these simple
remedies rst.
No sound from either speaker:
Incorrect source selected on receiver or preamplier.•
Mute button pressed on receiver.•
Wrong speaker output selected; many receivers have an "A" and "B" speaker •
switch. Make sure it is in the correct position.
In-wall Volume control not turned up or wired incorrectly.•
If using a speaker selector, room/station not turned on or improperly •
connected.
No sound from one speaker:
Unsecured connection at either the speaker or amplier - double-check all •
connections.
Balance control turned all the way left or right - return it to center.•
Bad connecting cable between sound source and amplier - try a new •
cable.
Check for stray wire strands crossing the speaker terminals. •
Defective speaker - contact your Russound dealer or call Russound Tech •
Support at 603.659.5170.
Any other problems not listed, discuss with your dealer or call Russound.•
Conguring Your Receiver
Your home theater receiver or surround processor most likely has a choice of
settings for dierent types of speakers. If your receiver or processor has an auto
setup procedure, you will probably get the best results using the auto setup.
If you use a manual speaker setup procedure, you will get the best results by
setting the LCR speakers to the "Small" setting if you are using a subwoofer, or
the "Large" setting if you are not using a subwoofer.