Installation manual
10 Russound In-wall LCR Loudspeaker Installation Manual
TESTS AND ADJUSTMENTS
Listening Test
It’s a good idea to test everything at this point.
Turn on your stereo system or music source. Make sure that the volume 1.
control is turned down and that the balance control is set to center.
Gently turn up the volume. You should hear music coming out of your new 2.
Russound Speakers! (If you don’t, refer to the troubleshooting guide.)
Now rotate the stereo’s balance control all the way to the left. Sound should 3.
only come out of your left speaker. If it comes out of the right speaker, skip
to Step 5.
Rotate the balance control all the way to the right. Sound should only come 4.
out of the right speaker.
If sound comes from the right speaker when the stereo’s balance control is 5.
turned to the left, you’ll need to change the connections on the back of the
amplier/receiver. Note: Turn o the amplier. Swap the wires attached to
the left and right speaker terminals.
Tweeter Adjustment
The tweeters pivot and should be aimed toward the intended listener. Before
installing the grille, gently press on the outside of the tweeter ring as shown.
Adjusting the Frequency Response
Both models are equipped with a Treble frequency adjustment switch. Move
the switch to change the setting.
+3 dB: Increases the loudness of the selected frequency
-3 dB: Reduces the loudness of the selected frequency
0 dB: The frequency remains neutral (recommended start setting)
Grille Installation
After all adjustments and listening tests are made install the grille. Insert the
speaker grille by placing it over the speaker bae and aligning its edges in the
frame. Press gently into place, taking care not to scratch the frame nish or
bend the grille. In most installations, the grilles will t tightly without causing
vibration. If any audible vibration does occur, use the pre-cut lengths of special
damping/adhesive material.
Frequency Adjustment
Grille Installation
Treble
Installed Bae
Scrim Cloth
Smooth into the Grille
Grille
Press only on the outer ring
of the tweeter. Pressing on
the interior of the tweeter
dome will damage it!
Tweeter Adjustment
Outer Ring
Tweeter Dome