User manual

4
d FIT THE BASE
9 Unplug the appliance before assembly or disassembly.
10 Align the pip on the tube at the bottom of the body with the hole in the tube on top
of the base.
11 Push the body into the base till the pip clicks into the hole.
d FIT THE HANDLE
12 Align the pip on the side of the shaft with the hole in the tube at the top of the body.
13 Push the bottom of the shaft into the top of the body till the pip clicks into the hole.
14 If you’re not going to use the steam mop right away, wind the cable round the cable
hooks. If you are going to use it, leave the cable loose.
d FIT THE CLOTH
15 Loosen the ties.
16 Fit the cloth over the base.
17 Bring the edges of the cloth up and over the flange running round the base.
18 Tighten the ties to secure the cloth to the base.
C FILLING – WATER
19 Pull the water reservoir up and off the rear of the body.
20 Turn the reservoir upside down, and unscrew the cap.
21 Lift the cap and feed tube out of the reservoir.
22 Fill the reservoir with fresh cold water.
, Don’t add anything to the water – you may damage the appliance, you will destroy
the anti-scale cartridge.
23 Slide the feed tube into the reservoir, and screw on the cap.
24 Turn the reservoir right way up, and replace it in the body.
C FILLING – DETERGENT
25 Turn the detergent valve to ], otherwise you’ll lose the detergent.
26 Pull the detergent reservoir up and off the front of the body.
27 Turn the reservoir upside down, and unscrew the cap.
28 Lift the cap and feed tube out of the reservoir.
29 Dilute the detergent in accordance with the manufacturer’s instructions.
30 Fill the reservoir with the diluted detergent.
31 Slide the feed tube into the reservoir, and screw on the cap.
32 Turn the reservoir right way up, and replace it in the body.
C TILT OR LOCK?
33 The joint where the body meets the base has two positions.
34 Hold the front of the base gently with a foot while changing positions.
35 Push the handle forward to lock the handle/body upright.
36 The appliance is stable in this position.
37 Pull the handle back to unlock the handle/body, so the base moves freely (like an
upright vacuum cleaner).
C USING THE CARPET GLIDER
38 If you’re going to clean carpet, rest the base and cloth in the carpet glider.
39 This will reduce drag, and make moving the mop much easier.