User Manual

5
How to Use
This appliance is for household use only.
GETTING STARTED
• Remove all packing materials and any stickers.
• To register your product, go to www.prodprotect.com/russellhobbs.
• Clean all parts as instructed in CARE and MAINTENANCE section.
PARTS
1. Switch
2. Battery compartment
3. Batteries 4 x AA
(not included)
4. Motor unit
5. Spindle
6. Viewing window
7. Grinder
8. Bulb connection points
9. Brass connection pins
10. LED Light (not pictured)
11. Clear coasters (not pictured)
(Part# RHPK4100-01)
DISMANTLING
• Grip around the body of the motor unit and clear viewing window.
• Turn the cover to move the pointer from lock to unlock .
• Lift the motor unit o the grinder.
• Remove the battery compartment by grasping around the motor unit top and
body and turning to move the pointer from lock to unlock .
INSERT BATTERIES
• For maximum performance, always use good quality batteries.
• Fit 4 AA batteries (not included) into each motor unit.
• The polarities ("+" and "-") are marked on the battery compartment.
FILL THE GRINDERS
• Ensure you are using grinder quality seasoning.
• Fill the grinders with peppercorns, sea salt, dried herbs or spices.
• Do not overll; this will cause problems during reassembly.
ASSEMBLING
• Ret the motor unit to the grinder by aligning the pointer with the unlock
on the clear viewing window.
• Rotate the motor unit moving it into the lock position.
• Ret the battery compartment by aligning the pointer with the unlock on the
motor unit. Rotate the battery compartment moving it into the lock position.
ADJUST THE GRIND
• Tip the whole mill upside down and turn the grinder clockwise towards the
negative for a ner grind.
NOTE: Grind will become progressively finer as you rotate the grinder.
• Tip the mill the right way up and press the switch.
• Check the grind size and if required, readjust to suit by turning the grinder
counter-clockwise towards the positive .
NOTE: Do not turn the knob more than 6 complete rotations clockwise towards the "+".
This may unscrew the knob from the spindle.
• Do the same for the other mill.