instructions 0, 00 0 pr iz e dr aw EX w w TR F w .p R E A ro E y R du rew ear eg ct is re ar gu Se ter gis ds ar e on te g an de bac lin r.co alle tee ta k e n .
Read the instructions, keep them safe, pass them on if you pass the iron on. IMPORTANT SAFEGUARDS Follow basic safety precautions, including: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance.
• • • • • • • • Don’t unscrew the boiler access knob till the appliance has cooled down completely (at least 2 hours). Don’t put the iron in liquid. Don’t iron clothing while it’s being worn – you’ll burn or scald the wearer. Don’t touch the soleplate, and keep away from the steam coming from it. Don’t set the base unit on a soft, carpeted, or upholstered surface, as this may block the vents underneath the base unit. Don’t use the iron for any purpose other than those described in these instructions.
SWITCH ON 1. 2. 3. Set the iron on top of the base unit. Check that the clamps are in the release position (press U). Lift the iron off the base unit, unwind the steam pipe from its niche above the reservoir and cable storage, then set the iron back on the base unit. 4. Open the cable storage ((), pull out the plug and all the cable, thread the cable through the adjacent gap, and close the cable storage. 5. Put the plug into the power socket (switch the socket on, if it’s switchable).
If the soleplate is at a lower temperature than the one you’ve set, the thermostat light on the iron will glow, to let you know that the soleplate is heating up. When the soleplate reaches operating temperature, the thermostat light will go out, then cycle on and off as the thermostat works to maintain the temperature STEAM IRONING 1. 2. 3. 4. Set the temperature control to S or higher – otherwise the steam might condense on the soleplate, giving you water, instead of steam.
5. 6. Lift the iron off the base unit, wind the steam pipe into its niche above the reservoir and cable storage, then set the iron back on the base unit. Open the cable storage, replace the plug and cable, and close the cable storage. ANTI-SCALE CARTRIDGE To reduce scale build-up, you must change the anti-scale cartridge regularly. After 10 hours of steaming, the O light will glow to tell you that the cartridge needs to be replaced, and the boiler needs to be descaled.
WENVIRONMENTAL PROTECTION To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol mustn’t be disposed of with unsorted municipal waste, but recovered, reused, or recycled. SERVICE If you ring Customer Service, please have the Model No. to hand, as we won’t be able to help you without it. It’s on the rating plate (usually underneath the product). The product isn’t user-serviceable.
