User manual

4
U BEFORE USING FOR THE FIRST TIME
• Fill to max, boil, discard the water, then rinse, to remove
manufacturing dust, etc.
C POSITIONING
1 Put the stand on a stable, level surface.
2 Route the cable so it doesn’t overhang, and can’t be caught or
tripped over.
3 Wind excess cable beneath the stand.
C FILLING
4 Remove the kettle from the stand.
5 Press the lid lock to open the lid.
6 Fill with at least 2 cups of water, but don’t fill above max.
7 If you overfill, the kettle may spit boiling water.
8 Close the lid, and press it down, to lock it closed.
9 Check the lid is closed, or the kettle won’t switch off when it boils.
C SWITCHING ON
10 Put the kettle on the stand – take care not to spill.
11 Plug the stand into a power socket (switch the socket on).
12 Move the switch to 1 – the light will glow, the kettle will heat up.
C SWITCHING OFF
13 When the water boils, the kettle and light will switch off.
14 To switch off manually, move the switch to 0.
15 Lifting the kettle off the stand will also switch it off.
C GENERAL
16 Remove the kettle from the stand before pouring.
17 To prevent splashing, pour slowly and don’t over-tilt the kettle.
18 Don’t tilt the kettle backwards – water might get on to the
control area.
19 If this happens, let the kettle dry before use – sit it somewhere
warm for 12 hours.
20 Don’t worry about discolouration on the floor of the kettle. It’s
due to the bonding of the element to the kettle floor.