User manual

5
b) add the ingredients via the hole
c) replace the cap, and turn it anti-clockwise to lock it
8. Turn the jug anti-clockwise to unlock, and lift it off the motor
unit.
CRUSHING ICE
1. Start with half to threequarters of a cup of ice, or 4 to 6 cubes,
and add 15ml (1 tbsp) of water.
2. Put the lid on the blender, then turn the speed control to Y for
a second or so, check the state of the ice, and repeat till the ice
is the consistency that you need
CARE AND MAINTENANCE
1. Switch off (0) and unplug before cleaning.
2. Wipe the outside of the motor unit with a clean damp cloth.
3. Handwash the removable parts.
4. If you use a dishwasher, the harsh environment inside the
dishwasher will affect the surface finishes.
5. The damage should be cosmetic only, and should not affect the
operation of the appliance.
` You may wash these parts in a dishwasher.
BLADE UNIT
You may remove the blade unit for cleaning. This is best done with
the jug upside down.
1. Grip the jug handle with one hand.
2. Grip the bottom of the blade unit with the other hand.
3. Turn the blade unit clockwise till it comes loose from the jug
base.
4. Carefully, pull it up and out of the bottom of the jug.
5. Wash the seal and blade unit in warm soapy water, rinse, and air
dry.
6. Take great care with the blades – don’t handle them directly,
use a nylon washing-up brush.
7. Replace the seal round the blade unit.
8. Turn the blade unit upside down, and replace it in the bottom
of the jug base.
9. Turn the blade unit anti-clockwise to tighten it.
blender