User manual

4
• You may use the processor and disc for cutting/grating for up to
2 minutes. Any other use should be restricted to 1½ minutes.
After this, let the motor rest for 2 minutes.
HOUSEHOLD USE ONLY
PREPARATION
1. Sit the motor unit on a dry, firm, level surface.
2. Route the cable so it doesn’t overhang, and won’t trip or catch.
3. Lower the jug on to the motor unit, then turn the jug clockwise,
to lock it in place.
4. Remove the lid.
5. Put the ingredients into the jug – don’t fill past the max mark.
6. Put the lid on the jug.
7. Check that the speed control is set to 0.
8. Put the plug into the power socket (switch it on, if it’s
switchable).
SPEED CONTROL
1. Turn the speed control clockwise (1 = low, 2 = high).
2. Turn it back to 0 to turn the motor off.
3. Use low speed (1) for lighter applications, using mainly liquid
ingredients, and high speed (2) for heavier applications, using
mainly solid ingredients.
4. Turning it anti-clockwise to Y will give you a short burst at high
speed, for more precise control. In this direction, the control is
spring-loaded. When you let go, it’ll return to 0.
USING THE BLENDER
1. Lower the jug on to the motor unit, then turn the jug clockwise,
to lock it in place.
2. Remove the lid.
3. Put the ingredients into the jug – don’t fill past the max mark.
4. Place the lid onto the jug with the tab as shown in figure A.
5. Twist the lid clockwise to lock it (fig. B).
6. Align the pips on the cap with the slots in the hole, fit the cap in
the hole, and turn clockwise. Don’t run the blender without the
cap.
7. To add ingredients while the motor is running:
a) turn the cap clockwise to unlock it, and lift it off