Product specifications

3
7 Don’t put utensils into the jug while the appliance is plugged in.
9 Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or
removing the jug from the motor unit.
10 Don’t let the jug overflow, any liquid under the motor unit may be sucked into the motor.
11 Don’t use accessories or attachments other than those we supply.
12 Don’t use the appliance for any purpose other than those described in these instructions.
13 Don’t operate the appliance if it’s damaged or malfunctions.
household use only
C PREPARATION
1 Sit the motor unit on a dry, firm, level surface.
2 Align the d on the bottom of the jug with the U on the motor unit.
3 Lower the jug on to the motor unit, then turn the jug to align the d with the L.
4 Press the lever to open the lid.
5 Put the ingredients into the jug. Don’t fill past the 1500ml mark, or the contents may force
the lid off when you start the motor.
6 Don’t fill with anything hotter than you can comfortably handle (i.e. liquid temperature
below 40°C).
7 Close the lid, and press it down to seal it.
8 Align the pips on the sides of the cap with the slots in the hole in the lid, put the cap into the
hole, and turn it clockwise to lock it.
9 Don’t run the blender without the cap.
C POWER UP
10 Check that the speed control is set to 0.
11 Put the plug into the power socket (switch it on, if it’s switchable).
C SPEED CONTROL
12 Turn the speed control clockwise (1 = low, 2 = high).
13 Turn it back to 0 to turn the motor off.
14 Use low speed (1) for lighter applications, using mainly liquid ingredients, and high speed (2)
for heavier applications, using mainly solid ingredients.
15 Turning it anti-clockwise to Y will give you a short burst at high speed, for more precise
control. In this direction, the control is spring-loaded. When you let go, it’ll return to 0.
16 Don’t run the motor for more than 1 minute, it may overheat. After 1 minute switch off for at
least 2 minutes, to allow it to recover.
C ADDING INGREDIENTS
17 To add ingredients while the blender is working, remove the cap, pour the new ingredients
via the hole, then replace the cap, and lock it in place.
18 Check that the added ingredients don’t push the volume in the jug past 1500ml.
C FINISHED?
19 Turn the speed control to 0, and wait till the blades stop moving.
20 Turn the jug to align the d with the U to unlock it, and lift it off the motor unit.
C USING THE MILL
21 Turn the mill base and bowl upside down.
22 Put the goods to be ground into the bowl – dry goods only.
23 Lower the mill base on to the bowl, then twist the base to the right, to lock it in place.
24 Turn the combined mill base and bowl the right way up.
25 Align the d on the bottom of the mill base with the U on the motor unit.
26 Lower the mill on to the motor unit, then turn, to align the d with the L.
27 Turn the speed control to Y in short bursts till you achieve the size of grind you want.
28 Turn the mill base to align the d with the U, and lift it off the motor unit.