User manual

RUSH PAR 2 RGBW Zoom User Manual 23
3. Clean the LED lenses by wiping gently with a soft, clean lint-free cloth
moistened with a weak detergent solution. Do not rub the surface hard: lift
particles off with a soft repeated press. Dry with a soft, clean, lint-free cloth
or low-pressure compressed air. Remove stuck particles with an
unscented tissue or cotton swab moistened with glass cleaner or distilled
water.
4. Check that the fixture is dry before reapplying power.
Fuse replacement
If the fixture is completely dead, the fixture’s primary fuse F1 may have blown
and it may be necessary to install a new fuse. This fuse is located in a
fuseholder next to the Mains OUT socket on the connections panel (see 5 in
‘Fixture overview’ on page 12).
To change the fuse:
1. Disconnect the fixture from power and allow it to cool for at least 15
minutes.
2. Use a large flat-bladed screwdriver to unscrew the cap of the fuseholder.
3. Replace the fuse with one of the same type and rating only.
4. Reinstall the fuseholder cap before reapplying power.
Service and repairs
There are no user serviceable parts inside the fixture. Do not open the
housing.
Do not try to repair the fixture by yourself as this may result in damage,
malfunction and it may potentially void your product warranty. The equipment
must only be serviced or repaired by an authorized RUSH by Martin service
technician.
Installation, on-site service and maintenance can be provided worldwide by
the Martin Professional Global Service organization and its approved agents,
giving owners access to Martin’s expertise and product knowledge in a
partnership that will ensure the highest level of performance throughout the
product’s lifetime. Please contact your RUSH by Martin supplier for details.