Owners manual

Parts List
Assembly Tips:
Attention: If you are using an electric screw driver in assembly, please set at low torque and
do not over tighten the hardware. When assembling individual parts, loosely tighten screws
until all screws are inserted, then tighten completely.
Mounting Instructions :
Step 1.
Find the wall studs in the area you want to hang your rack.
Step 2.
Hold the lower section of the rod holder (#2) on the wall and use a level to even it horizontally
from side to side. Mark the mounting hole positions with a pencil as a reference for drilling.
Step 3.
Hold the upper section of the rod holder (#1) in place with your hand, level from side to side
and mark the mounting points. Make sure the top and bottom section of the holder are in line
with each other.
Step 4.
Drill pilot holes with a drill. Insert wall anchors(#5) into the holes. Tighten screws (#4) into the
wall with screwdriver. Now you are ready to hang your rack.