Operation Manual

Page 11 of 16
the screen you can see on which channel the
chest strap is sending.
Should you wish to change the channel, press
the button on the chest strap as described
above to switch to the next coded channel,
and then press the button “Re-Pair” and your
smartphone will establish a connection to the
chest strap again.
Android operating systems:
Go to "Settings" and select "Heart Rate
Settings", under point "Sensor Channel" you
can see on which channel the chest strap is
sending. If it is using a coded channel, it
shows a digit. If it uses the uncoded channel,
it reads “Uncoded”. Should you wish to
change the channel, you have to disconnect
the chest strap from the receiver by switching
to “No pulse connection”. Now switch the
channel as described above by pressing the
button on the chest strap. Switch to point
"Receiver + Chest strap (5.3 kHz)" again,
your smartphone will establish a connection
to the chest strap again on the new channel.
BlackBerry:
Go to "Settings" and select "Heart Rate
Settings", under point "Sensor Channel" you
can see on which channel the chest strap is
sending. If it is using a coded channel, it
shows a digit. If it uses the uncoded channel,
it reads “Uncoded”. Should you wish to
change the channel, press the button on the
chest strap as described above to switch to