Operation Manual

52
To charge the accumulator, proceed as follows:
Fix the clip of USB cable on the GPS watch according to the following image
and insert the USB cable in a USB connected to power from your computer.
The installation of a driver for charging the accumulator is not necessary.
During the charging process the following symbol appears on the screen:
The charging of an empty accumulator takes approximately 2 hours.
When the accumulator is fully charged, the display "battery full" appears.
9.2 Replacement of the battery of chest strap
Open the cover of the battery compartment
with a coin, rotating counterclockwise. Take the
old battery and place a new one of 3 V type
CR2032. Make sure the plus pole (+) shows
upwards. Put back the cover from the battery
compartment and close it again, rotating
clockwise. Make sure the cover is well closed,