Operation Manual

28
Timer use:
 In the display mode Timer press the „ST./STP" button to start or stop
the timer.
 If the timer is stopped, press the "LAP/RESET" button, to reset the timer
at the time set previously.
 When timing is finished, during the last 10 seconds a Beep will be given
for each second. When it reaches to 0, a longer Beep will be heard.
Press any key to stop this Beep tone.
6.2.4 Alarm
In Time-mode press the „VIEW” button until the following display appears on
the display:
 Press the „ST./STP.” button, to select the alarm 1-5.
 Press the „LAP/RESET” button to set the alarm "ON" (enabled) or "OFF"
(disabled).
Setting of alarm time and alarm format:
 In the setting mode select „Settings” point from the menu  select
„Alarms“.
 Then select from alarms 1-5 and adjust alarm hours and minutes,
"ON/OFF" will blink.
 Then adjust the alarm "ON" (activated) or "OFF" (deactivated), the
alarm format will blink:
Alarm time
Alarm format
Alarm 1-5
Alarm „ON”
„OFF”