Operation Manual

24
System reset operation
 In the setting mode select „Settings” point from the menu 
„System“
 „Sys Reset“.
 Then select "On" to perform a system reset. By this, all the values, all
the basic settings will be reset and all the data (paths, reference points,
training histories, etc.) deleted.
Select "Off" in order not to reset the system.
6.1.3 Memory status programming
In the adjustment mode select the menu point "Memory" until the following
display appears:
The memory use level of the GPS watch will be indicated in %. 1% of the
memory corresponds to approximately 480 in memorized reference points
for the GPS watch.
CAUTION:
Keep in mind that the watch does not delete automatically the memory with
your data. To this effect, when transferring the data from the watch in your
computer, you must activate automatic memory deletion at a data transfer
from Runtastic Connect, in settings/options. If the memory of the watch is
full, no timing will be performed, a training timing in workout mode can not
be started any more. This means that the ST./STP. cannot be pushed
anymore. Still, before the memory is full, the notification “Memory full!”
appears on the display of the GPS watch
Memory usage level