Instructions / Assembly

Page 9 of 13
FOR YOUR SAFETY, READ BEFORE LIGHTING
• Before performing a leak test, make sure that no sparks can occur and you
are in a spacious outdoor area.
• Connect the propane gas tank to the regulator and turn the valve on the
unit to the “off” position.
• Brush a soap and water mixture on all connections.
• Make sure the igniter battery has been installed properly. The igniter will
not operate otherwise.
• Before operating, smell around the appliance and next to the ground for
gas odors. If you smell gas or a leak is discovered turn the gas valve off,
disconnect propane gas tank and do not use the appliance until the leak is
repaired.
• The Fire Table has a Door. Open the door and inspect the Gas Hose
before use the Fire Table.
• If there are signs of wear or abrasion on the hose, you must replace the
Gas Hose. And the Gas Hose must be supplied directly by manufacturer.
•
Stand away from the Fire Table / Column for the initial 20 minutes after
igniting.
• Lava rocks / pumice stones could pop up and strike somebody’s face
during the process of lighting this unit.
•
Pumice stones/lava rocks/Lava Glass could pop up and strike somebody’s
face during the process of lighting this unit; Wait 10 minutes after
extinguishing flame prior to replacing a lid (if applicable) or protective
cover onto the Fire Table.
Operation