User's Manual

PicoPlus Base Station User Manual RCMS Application
Runcom Technologies Ltd. CONFIDENTIAL 31
4.2 Settings Tab
The Settings tab includes the following areas:
• BS Settings – used to configure BS parameters and sector features
• ARP Table Entries – used to define the MAC addresses of the connected CPEs
• SW download – used to update BS SW and FPGAs (described in Chapter 5.2)
This section describes the parameters provided in each area.
4.2.1 BS Settings
The following table describes the parameters provided in BS Settings area.
Note: Click the (Update) BS Settings button to save the changes on to the BS.
Parameter Description
Sector Frequency [KHz] Center frequency
Boot Mode Specifies the MAC layer Boot Mode. Values:
o 2 – Waiting for Access Control Router (ACR)
activation; All parameters are retrieved from the ACR.
o 1 – Activation is done immediately upon power up
(not waiting for ACR); Parameters are taken from the
GDB memory.
o 0 – Waits for ACR activation. Parameters are taken
from the GDB memory.
BS Settings
Area: basic
parameters
Enter MAC
address of
every
CPE
Click to save
changes
SW Download
Area