User's Manual

CPE-O-R-WS User Manual
28 Runcom Technologies Ltd.
4.10 Viewing Wireless status and Information
The WiMAX status and information page includes important information which assist operator and installer to identify
proper installation and operation of CPE device
Figure 21: WiMAX Interface Status and Information
4.10.1 Networking Status
 Connection Status: shows the air interface state status
 BS ID – if not 00:00:00… shows the ID of the base station which the CPE is connected to
 Frequency – shows the channel which is selected to connect to the BTS
 RSSI – the radio signal strength that the CPE receive the BTS
 Tx Power – the TX power which the BTS request from the CPE to transmit
 CINR – the calculated signal to noise ratio.