User's Manual

CPE-O-R-WS User Manual
12 Runcom Technologies Ltd.
3.5 Preparations before physical installation
3.5.1 Skills Required
The CPE-O-RS-WS shall be installed by a professional installer that was qualified to install TVWS equipment.
It is forbidden to install the CPE-O-RS-WS by non-professional installer.
3.5.2 Information Needed before
The professional installer shall gathered the following information prior to the installation
 Locations of the Base Station and the azimuth from the CPE to the Base Station, which you should be able to
connect to.
 Log in account and password
3.5.3 Required Tools and Equipment
This section lists all the extra tools and equipment mentioned in this guide that you will need to perform the installation.
None of the items listed in Table 2-1 are supplied with the kit, so make sure you gather everything you need before you
start. Use the table below to check exactly what you will need (this will depend on where you are going to install the
outdoor transceiver).
Table 4: Required Tools and Extra Equipment
Tools Required
Extra Equipment Required
Compass
Grounding clamp
Area map with an accurate direction
legend showing magnetic north
Grounding wire
Flat-head screwdriver
Roll of UTP CAT 5 cable
Hammer or mallet
Cable clip
Power drill
Anchor sleeves
1/8 inch drill bit
RJ-45 connectors (plastic bodied)
3/16 inch, 4mm hex (Allen) wrench
1 inch copper tape
Bubble level or plumb line
Adjustable wrench
Crimping tool (must be specifically
matched for the RJ-45 connector used)
Wire stripper
Small wire cutters
Punch down tool