User's Manual

CPE-O-R-WS User Manual
10 Runcom Technologies Ltd.
will not be able to transmit again until it will be synchronized with the Base Station in a new channel allocated by
the TVWS Data Base via AFAS
3.4.3 CPE-O-RS-WS relocation
In case the CPE is relocated to a different location than the location registered in the Data Base, the installer shall do
a new registration according to paragraph 3.4.4 below prior to turning on the relocated CPE. The relocation must be
to a new location that is covered by a registered TVWS Base Station.
3.4.4 Adding of CPE-O-RS-WS to the AFAS
To add a CPE in the AFAS open the “Site administration” page in the AFAS and Choose CPE as shown in
Figure 3 below.
Figure 5: AFAS Site administration page
The AFAS SW will open the “Select CPE” page, on this page click the “Add cpe” option as shown in figure 4 below.
Figure 6: AFAS Select CPE page
On the “Add cpe” page fill the CPE ID, CPE IP, CPE Latitude and Longitude, the Connecting Base ID, The CPE
antenna Height, MAC ID and save it as shown in Figure 5 below: