User Manual

AFAS operation Manual
12 Runcom Technologies Ltd.
After entering to the "add base station" form the following page
should be filling with the following information
Figure 11: Add base Station page 1- Device Information
 Base Station ID : Logical name of the BS which helps to identify it – use
for AFAS only
 Base Station IP: the IP address of the base station as presented in the
xNOC device
 GIS information: Base Longitude, Base Latitude the location of the
base station. Keep "0" for automatic update from the BS unit.
 Base Antenna Height: the height of the antennas element. If more than
one antenna is used, enter the highest antenna parameter.
 Preferred channel: During installation it is recommended to measure all
possible channels and to use the best. Enter the best first in row, and
followed by comma the second best and so on. If "0" is entering the
AFAS will use its algorithm to select channel.
 Channel bandwidth: It is possible to use single channel or two adjacent
channels if found. 5MHz is single 6 MHz channel; 10MHz is two adjacent
channels – 12 MHz