User's Manual

RNU4000BS Base Station User Manual
Runcom Technologies Ltd. 33
2. Assemble the bracket elements:
• Secure the WALL/POLE BRACKET to the Bracket Arm and then to the
BracketBase using the provided screws, as shown below:
Note: The bolt head should be positioned in the socket on the Bracket BASE.
• Use a tightening torque of 24 N/m to tighten.
3. Mount the BS on the pole, where the procedure varies slightly according to the pole
diameter:
For poles with a diameter of 1.75-3.00”:
• Mount the BS on the pole using the bracket Pole Support as shown above.
Assemble the bracket CONVEX as shown.
• Tighten the bracket using the provided screws, according to the pole diameter.
• Use a tightening torque of 14N/m to tighten.
WALL/POLE BRACKET
ARM
BASE - connect
to BS
Washers and bolt
Ridges to
ridges
POLE SUPPORT
Assembled CONVEX on the pole