User's Manual

RNU4000BS Base Station User Manual
Runcom Technologies Ltd. 25
3.2 Connect BS to Power and Computer
ATTENTION!!! BE SURE THE RF ANTENNAS ARE CONNECTED OR THE RF
PORTS ARE TERMINATED BEFORE CONNECTING POWER TO THE UNIT.
To commission the BS unit two setup connections are required:
• Power - Use the provided (BS) power cable to connect the BS VDC Power connector to
an indoor 48 VDC power supply.
• Computer – Connect the BS ETHER port to the computer running the WEB GUI
application.
Figure 22 BS Commissioning Setup
3.2.1 Configure the Computer's Network Parameters
In order to establish communication between the computer and the BS perform the
following:
• Assign computer IP address in the same subnet as the BS
• Disable Firewall
3.2.1.1 Configure Computer IP Address
To configure IP address follows the next steps:
Note: The procedure may vary slightly depending on the operating system installed on the
computer. The following procedure is for Windows XP.
1. Click the Start menu and choose Network Connections.
2. Right-click the Local Area Connectioncorresponding to the BS connection and select
Properties.
48VDC