User's Manual

RNU4000BS Base Station User Manual האיגש ! ליחהל ידכ תיב היסיטרכב שמתשה Heading 1 ןאכ עיפויש ךנוצרבש טסקטה לע.
• Disconnect the power source before installing or maintaining the power wiring.
• Do not operate the equipment if there is any failure or damage to electrical
components.
• Do not touch exposed connections, components or wiring when power is on.
• Install the equipment and the grounded DC supply circuits in adjacent cabinets.
• Protect the DC power source with an adjacent circuit breaker.
• The equipment must be properly grounded before attempting to operate or perform any
repairs.
RF Exposure
To comply with FCC Section 1.310 for human exposure to radio frequency electromagnetic
fields, implement the following instruction:
A distance of at least 200cm between the equipment and all persons should be
maintained during the operation of the equipment.
Radio Interference
This equipment generates and radiates radio frequency energy and if not installed and used
in accordance with the instruction manual, may cause interference to radio communications.
To avoid interferences:
• Avoid conjunction with any other antenna or transmitter.
• In case of Radio Interference: Relocate the antenna and Increase separation between
the equipment and the receiver (e.g. connect to a separate circuit or outlet).
• When using an external antenna, the external antenna must not be co-located or
operating in conjunction with any other antenna or transmitter
NOTE: This equipment has been tested and found to comply with the rules for TV bands devices,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Note:
Contention Based Protocol (CBP) MUST be activated for the specified band (3.675-3.700GHz)
wherever FCC rules and regulations are enforced. Failure to comply makes the operation of this device
illegal.