Specifications

Operation
68 Runco LS-10d and LS-10HBd Installation/Operation Manual
PRE
L
IMINAR
Y
• Splash Timer: When you turn on the LS-10, it projects a welcome screen with the
Runco and ISF logos, along with the personalized information you enter as described
above. Select Splash Timer from the Splash Configure menu to set the amount of time
for which this screen appears. The range is from 5 to 60 seconds, in one-second
increments. Press or to set the timer, then press MENU.
• Splash Enable: When you have finished customizing the splash screen, select Splash
Enable from the Splash Configure menu. Then, select On and press ENTER.
OSD Position: To adjust the position of the OSD, select OSD Position from the
Calibration menu and press ENTER.
Press or to select “Hor.” or “Ver.” Then, press or to change the position.
Service Use the Service menu to access advanced projector configuration settings. This menu
should be used by ISF-certified technicians only.
Test Video: Select Test Video from the Service Menu to access the internal test patterns
on the DHD Controller. Table 4-4 lists the available test patterns and describes their
suggested usage. To exit test pattern mode, press MENU.
Service
Test Video
Input Names
Display Device
Network
Color Space
Triggers
Miscellaneous
Sync Threshold
HDMI
Front Panel Brightness
Auto Power Off
Standby Mode
System Reset
➤
You must enter a passcode to access the Service menu.
Table 4-4. Test Patterns and Their Suggested Usage
Pattern Suggested Usage
Color Bars 1
Use this pattern when making
color saturation and tint
adjustments.
Color Bars 2
Use this pattern when making
color saturation and tint
adjustments.
Focus
Use this pattern when adjusting
the focus.
Note