Installation guide

Adjusting Color Balance
62 Runco WindowWall Installation Guide
1 Turn on all the displays in the array and let them warm up for at least five
minutes. The backlights must be thoroughly warm before you color balance.
2 Press MISC twice on the remote to open the BACKLIGHT CONTROL menu. Confirm
that the BACKLIGHT INTENSITY is greater than 1.
3 Open the COLOR BALANCE menu by pressing BALANCE on the remote.
Note: The color balance menu is a local menu. For more information about navigating local
menus, see "Local Menus" on page 54.
4
Press the ** button to show the menu on all displays.
Backlight Control
Auto Backlight on
Turn Backlight Off When No Source (DPMS)
DPMS Delay 1 hr
Backlight Intensity 10
Color Balance
Color Temperature Native
White Test Pattern
White Balance - All (Clipboard)
Red 100 (100)
Green 100 (100)
Blue 100 (100)
Gray Test Pattern
Gray Balance - All
Red 7 (7)
Green 7 (7)
Blue 7 (7)
Backlight Adjustment +0
Copy to Clipboard
Recall From Clipboard
Reset to Defaults
Remove Test Pattern