Installation guide

Runco WindowWall Installation Guide 59
Matrix Layout Menu
The Runco WindowWall LCDs are equipped with sensors that allow them to know
their position in the array. The master (A1) keeps track of this information and
displays it in the layout menu. To start the automatic discovery process, go to the
MATRIX LAYOUT MENU (MAIN MENU > WALL CONFIGURATION > MATRIX LAYOUT) and select
the AUTO option. The discovery process takes about 5-10 seconds for the entire wall.
Caution: You must complete this step before performing any other on-screen menu
configurations!
Note: The first time you open this menu, it will be populated from A1 all the way through P4,
no matter how many modules you have.
Depending on how your wall is set up, one of four scenarios could occur:
• Auto Layout Complete - The discovery process completed without errors.
• No Auto Layout has been performed. See "Troubleshooting" on page 133.
• Error in the Layout - This might appear if an LCD is in service mode. See
"Troubleshooting" on page 133.
• If your array is larger than nine wide or nine high, you will not be able to see the
entire layout on this menu. A message will appear that indicates this.
Matrix Layout
Auto Quick Reset
**
A1 A2 A3
B1 B2 B3
C1 C2 C3