Installation guide

Menus and the Remote
50 Runco WindowWall Installation Guide
Menus and the Remote
All on-screen menus are controlled using a specific remote control created for the
Runco WindowWall display wall. This remote allows you to access the four menu
types: navigational, global, local and status. These menus are described below.
Note: Keep in mind that you need to point the remote towards where the IR sensor is
mounted.
Number Definition
1Turn the display ON/OFF.
2 Move the target left or right.
3 Set the target to all at once.
4 With each press, go to Picture, Input Levels, Aspect Ratio,
Picture Position, Zoom Top & Left, Zoom Bottom and
Right.
5 Press once for Miscellaneous Options, twice for Backlight
Settings, three times for Serial Port Settings.
6 Press once for Recall, twice for Save.
7 Takes you to the next Quick Configure setting (Big
Picture, A1, A2, etc.)
8 Press once for the Color Balance menu.
1
2
4
3
5
6
7
8
9
10
11
12
13
14
15