Specifications

Operation
50 Runco RS-440 Installation/Operation Manual
PRE
L
IMINAR
Y
• Phase: Adjust the phase if the image (usually from an RGB source) shows shimmer or
“noise.” Pixel phase adjusts the phase of the pixel sampling clock relative to the
incoming signal. The effect of this control is similar to that of a tracking control on a
VCR.
For best results, use a good test pattern such as a smooth gray consisting of a clear
pattern of black and white pixels, or a similar “half on, half off” graphic image. (You may
find that you can stabilize the image at more than one point. Use either setting in this
case.)
• Reset: Select Reset from the YUV/RGB Adjust menu to restore the position, clock and
phase settings to their factory-default values.
OSD Timeout: This timer controls how long the menus remain on-screen after selecting
them. Select a time-out period of 0, 5, 15 or 60 seconds. When you set the
OSD Timeout
to 0, the menus remain on-screen until you hide them by pressing MENU.
Vertical Correction (RS-440LT/CineWide only): To achieve the proper image
geometry with the secondary anamorphic lens, select
Vertical Correction from the
Installation menu. Then, use the or button to change the native aspect ratio of the
display, in small increments.
The range is from 0 through 5 in increments of 1. Each increment reduces the image
height by one percent. A value of 5, for example, reduces the image height by 5 percent.
Information Select Information from the Main Menu to see projector status information: the
currently-active source, input signal resolution, aspect ratio, picture memory and lamp
usage. This menu also displays the projector serial number.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
Information
Source HDMI
Resolution 720x480
H. Frequency 15.7 KHZ
V. Frequency 59.8 HZ
Aspect Ratio 16:9
Picture Memory ISF Night
Lamp Hours 450
Firmware 0014.006
Serial RUP440RS0803001
➤