Specifications

Operation

Runco RS-440 Installation/Operation Manual 47

PRE

IMINAR

InstallationTo access the Installation adjustments, press MENU, then press the or button to

highlight Installation and press ENTER. The Installation sub-menu appears. Press EXIT to

return to the previous menu or press MENU to close all menus.

Language: Select Language from the Installation menu and press ENTER. Then, use the

or button to select from the available languages: English, French, Spanish, German

and Italian.

Orientation: Select Orientation from the Installation menu and press ENTER. Then, use

the or button to change the orientation of the projected image. The RS-440 can be

installed on a ceiling or in a rear-screen configuration with one or more mirrors. There are

four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling Rear.

Keystone: Projector placement and other factors can cause geometric distortion in the

projected image. To correct this, select

Keystone from the Installation menu. This

sub-menu provides the following options:

• V. Keystone/H. Keystone: To correct distortion resulting from the angle of projection,

select

V. Keystone or H. Keystone from the Keystone menu and use the or button

to make the image rectangular. See Figure 4-6.

Installation

Language

Orientation

Keystone

Overscan

YUV/RGB Adjust

OSD Timeout

Vertical Correction

When you change a setting in the Installation menu, the change takes

effect immediately; you do not need to press ENTER afterwards.

(Press EXIT to return to the previous menu or MENU to exit.)

Note

V. Keystone 0

H. Keystone 0

Runco recommends that the keystone feature not be used unless

absolutely necessary, as it may cause artifacts in the image.

1. The RS-440 keystone correction can compensate for up to

approximately 15 degrees of screen and/or projector tilt.

2. Straight lines or the edges of images may appear jagged while

adjusting the image.

Tip

Note