Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Projection Lens, Lamp and Cooling
- 3.5 Installing the Optional CineWide Lens Mount
- 3.6 Mounting the SC-1
- 3.7 Connections to the SC-1 and DHD Controller
- Input Panel Access
- Connecting the DHD Controller to the SC-1
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-volt Trigger Outputs to External Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting an External Power Supply/Ballast to the Projection Head
- Connecting to AC Power
- 3.8 Turning on the Power
- 3.9 Maximizing Light Output
- 3.10 Adjusting the Picture Orientation
- 3.11 Primary Lens Adjustments
- 3.12 Installing and Adjusting the CineWide Anamorphic Lens
- 3.13 Calibrating Projector Input 2 (DVI)
- 3.14 Working With the Lamp
- 4. Operation
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
Installation
34 Runco SC-1 Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting Source
Components to
the DHD
Controller
Connect your video sources to the DHD Controller as shown and described in the
sections that follow.
HDMI Connections: See Figure 3-14.
Figure 3-14. HDMI Source Connections
➤
Use the HDMI inputs whenever possible. This ensures the highest
video quality because the signal is carried in the digital domain
throughout the entire signal path, from source component output
into the projector.
You can also connect computers with DVI output to these inputs.
However, accepted VESA standard resolutions are limited to VGA
(640x480), SVGA (800x600), XGA (1024x768) and SXGA
(1280x1024) at 60Hz refresh.
Tip
Note
HD1
HD2
G/Y
INPUTS
HVR/Pr B/Pb
G/Y H VR/Pr B/Pb
Component Video
Pb
Pr Y
Video S-Video 2
S-Video 1
IR12 3
TRIGGERS
HDMI 1 HDMI 2
HDMI Source
(HD-DVD/BD/DVD Player or
HD Tuner with
HDMI or DVI out)