Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Projection Lens, Lamp and Cooling
- 3.5 Installing the Optional CineWide Lens Mount
- 3.6 Mounting the SC-1
- 3.7 Connections to the SC-1 and DHD Controller
- Input Panel Access
- Connecting the DHD Controller to the SC-1
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-volt Trigger Outputs to External Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting an External Power Supply/Ballast to the Projection Head
- Connecting to AC Power
- 3.8 Turning on the Power
- 3.9 Maximizing Light Output
- 3.10 Adjusting the Picture Orientation
- 3.11 Primary Lens Adjustments
- 3.12 Installing and Adjusting the CineWide Anamorphic Lens
- 3.13 Calibrating Projector Input 2 (DVI)
- 3.14 Working With the Lamp
- 4. Operation
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
List of Figures
xii Runco SC-1 Owner’s Operating Manual
PRE
L
IMINAR
Y
3-27. Anamorphic Lens Mouning Assembly - Exploded View.............................................49
3-28. Attaching the Anamorphic Lens to the Lens Ring .....................................................50
3-29. TheaterMaster Remote Control for SC-1 ..................................................................55
3-30. Channel Setup Menu................................................................................................58
3-31. Unlocking a Channel ................................................................................................59
3-32. Resize Presets: No Resizing .....................................................................................60
3-33. Adjusting Black Levels and White Levels Using the Peak Detector............................65
4-1. DHD Controller OSD Menu Structure for SC-1 ...........................................................70
4-2. Typical PLUGE Pattern for Adjusting Brightness .........................................................75
4-3. Typical Gray Bar Pattern for Adjusting Contrast ..........................................................76
4-4. Typical Color Bar Pattern for Adjusting Color Saturation and Tint................................76
4-5. Typical Test Pattern for Adjusting Sharpness..............................................................78
4-6. Keystone Correction...................................................................................................83
5-1. Disconnecting the Old Lamp ......................................................................................92
5-2. Installing A New Lamp................................................................................................93
5-3. Securing Lamp Anode (+) and Cathode (-) Connectors...............................................93
5-4. Recording the Serial Number of a New Lamp .............................................................94
7-1. SC-1 Dimensions (with Built-In Power Supply/Lamp Ballast).....................................110
7-2. SC-1 Dimensions (without Built-In Power Supply/Lamp Ballast)................................111