U SER ’ S M ANUAL DLC-2000HD Projection System Liquid Crystal Projector & Pixel-For-PixelTM Controller with VivixTM Technology
Table of Contents Limited Warranty ................................................................................................ 1 Introduction ........................................................................................................ 3 Warnings and Safety Precautions .................................................................... 4 Warning .......................................................................................................... 5 Safety Tips ..........................
Limited Warranty LIMITED WARRANTY Congratulations on your purchase of a Runco video product and welcome to the Runco family! We believe Runco produces “The World’s Finest Home Theater Products”. With proper installation, setup and care, you should enjoy many years of unparalleled video performance. Please read this consumer protection plan carefully and retain it with your other important documents. This is a LIMITED WARRANTY as defined by the U.S.
EFFECTIVE WARRANTY DATE: This warranty begins on the effective date of delivery to the end user. For your convenience, keep the original bill of sale as evidence of the purchase date. IMPORTANT: WARRANTY REGISTRATION: Please fill out and mail your warranty registration card. It is imperative that Runco knows how to reach you promptly if we should discover a safety problem or product update for which you must be notified.
Introduction Congratulations on your purchase of the DLC-2000HD system! This system was designed to be a fully integrated system, which includes the DLC-2000HD Projector and the unique PFP™ Controller. This system is extremely easy to use, as all of the controls for the Projector have been integrated into the PFP Controller for ease of operation and control.
Warnings and Safety Precautions CAUTION: To turn off main power, be sure to remove the plugs from power outlets. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. REMARQUE: Pour mettre l’appareil hors circut, s’assurer de retirer la fiche de la prise d’alimentation. La prise d’alimentation doit être installé aussi proche que possible de l’appareil et doit être facile d’ accès.
WARNING This equipment has been tested and found to comply with the limits for a Class ‘B’ digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the Installation Manual, may cause harmful interference to radio communications.
Indicator Lights Top View The Projector has four lights which provide a status of the operation of the Projector. These are described below: Lamp warning Lamp warning: Lights up YELLOW when the lamp has reached its useable life expectancy (1500 hours). Temp. warning Ready Standby Ready: Lights GREEN when the Projector is ready for use. Standby: Lights when Projector is in the standby mode; dims when in operation. Temp warning: Flashes RED when the internal temperature is too high.
Front and Rear Panel Descriptions Front Panel 1 2 3 ratio < enter > i n p u t menu < < ratio TM PIXEL 4 IR RECEIVER Receives the infrared signal from the remote control. 2. POWER BUTTON Turns the unit ON or OFF. The Main Power switch on the rear of the unit must be on first for this button to be active. 3. POWER INDICATOR When the PFP Controller is ON, this LED will illuminate GREEN. When the unit is OFF or in STANDBY, this LED will illuminate RED. A flashing red light indicates a fault.
Rear Panel 5 1 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN RUNCO INTERNATIONAL HAYWARD, CA ! MADE IN USA AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR COMLINK OUT CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE CENTER.
Remote Control Description A. IR OUTPUT INDICATOR Illuminates when a button is pressed, indicating that an IR signal is being transmitted. A B B. POWER BUTTON Toggles the power on and off. For a discreet on or off command, you can use the direct access buttons (see 'J'). Note: When the main AC power switch is first turned ON, the Controller will go through an initiation cycle for approximately 15 seconds. The Controller cannot be turned on or operated until the initialization is complete. G D C.
Menu Description and Navigation Menu Tree INPUT SELECT Standard Video: > Composite S-Video Component High Definition: Component RGB Anamorphic Standard 4:3 ASPECT RATIO SELECT Letterbox Main Menu Through the Main Menu, you can easily switch sources and Aspect Ratios. To select a source, you may either use the direct access buttons on the remote (pg. 9) or the Left/Right buttons on the remote or Front Panel (pgs. 7, 10).
Specifications DLC-2000HD Projector: Projector Type: LCD Native Resolution: 1366 x 768 Lamp: 250W Metal Halide Inputs: RGB/Component Bandwidth: 180 Mhz (RGB) Power Requirements: 100-120 VAC, 200-240 VAC 50/60 Hz (export version) Current: 3.3A (100-120 VAC), 1.7A (200-240 VAC) Power Consumption: 360W Dimensions: Width: 16.310 in. (414 mm) Depth: 25.801 in. (655 mm) Height: 8.439 in. (214 mm) Weight: 56 lbs. (25.
Controller: Inputs: (1) Component, (1) S-Video, (1) Composite, (1) HDTV/Computer Input standards: NTSC/PAL/480p/720p/1080i/SVGA/XGA Output format: 1366 x 768 Bandwidth: Video inputs: 5.5 Mhz, HDTV/Computer: 100 Mhz Power Input: 120V (220V export model), 50/60 Hz Power Consumption: 15W Control Options: RS-232, Infrared, Front Panel Operating Environment: 41°-95°F (5°-35° C), 0-90% humidity, Non-condensing Dimensions: Width: 17.45 in. (443.23 mm) Depth: 16 in. (406.40 mm) Height: 3.5 in. (88.
RUMA-006700 rev 11-03 Runco International . 2900 Faber Street . Union City, CA 94587 . ph (510) 324-7777 . fax (510) 324-9300 . www.runco.
