Owner`s manual

Installation

VX-3000 Installation/Operation Manual 47

PRE

IMINAR

6. Select the Cinema or Virtual Cinema aspect ratio to move the anamorphic lens into

position, if it isn’t already. To do this, press CINEMA or VCINE on the VX-3000

remote control (

Figure 2-4).

Adjusting the Horizontal (X) Lens Position:

1. Project a white field on the screen.

2. Loosen the Yaw/X-Adjustment Levers underneath the lens.

3. Slowly move the anamorphic lens into place (from right to left or vice versa) so that

there are no shadows on either side of the screen:

4. When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to

secure the lens in place.

Adjusting the Height (Y): With the white field still on-screen, loosen the

Height/Y

Adjustment T-Screws on either side of the lens. Then, slowly move the

anamorphic lens into place so that there are no shadows on the top or bottom of the

screen:

When the height is properly set, tighten the Height Adjustment T-Screws to secure the

lens in place.

Too Far Right

Too Far Left

Correct position

Too High

Too Low

Correct position