Owner`s manual

Installation

26 VX-3000 Installation/Operation Manual

PRE

IMINAR

3.5

Installing the Optional

CineWide/AutoScope

Lens Mount

If you are installing a standard (non-CineWide) VX-3000i, VX-3000d or VX-3000 Ultra, skip

this step and proceed with

Mounting the VX-3000 (page 36).

If you are installing a CineWide projector equipped with a prismatic

(Whitney) anamorphic lens, proceed with

Installing the Fixed CineWide

Base Plate (Prismatic Lens) (page 31).

If you are installing a CineWide projector equipped with a

cylindrical (Rainier

II or McKinley) anamorphic lens, proceed

with

Installing the Fixed CineWide Base Plate (Cylindrical

Lens) (page 33).

If you are installing a VX-3000i/CineWide with AutoScope, VX-3000d/CineWide with

AutoScope or VX-3000

Ultra/CineWide with AutoScope, proceed as follows to install the

AutoScope lens motor.

1. Do not install the CineWide lens yet, only the fixed CineWide

base plate or AutoScope lens motor. You will install the CineWide

lens after you install the projector and adjust the primary lens.

2. Some components shipped with your projector may differ slightly

from what is shown in these instructions.

Note