Owner`s manual

Installation
14 VX-3000 Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the VX-3000 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 15
2
Install primary projection lens (VX-3000 Ultra only) 22
3
If installing a CineWide-equipped projector: Install
AutoScope lens motor or fixed CineWide base plate
(optional)
26
4
Mount the projector 36
5
Connect signal sources to the VX-3000 37
6
Connect external controller to RS-232 port (optional) 40
7
Connect 12-volt trigger output to AutoScope lens motor or
other equipment (optional)
41
8
Apply power to the projector 42
9
Primary lens adjustments: focus, projected image size
(zoom) and position (shift)
18, 43
10
Change the OSD Language (optional) 43
11
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
44
12
Install CineWide anamorphic lens (optional) 44
13
CineWide lens adjustments: position, pitch (angle),
geometry and focus
47
14
Projector calibration: adjust the following for each input;
save settings when finished:
Aspect ratio
Brightness
Contrast
Color level
Tint
Input position
61 through 66
Note