Owner`s manual

Serial Communications
VideoWall™/CineWall™ Installer/Integrator Manual 69
PRE
L
IMINAR
Y
Table 5-4. Data-Only Response Examples
Command and Respond
Examples
Explanation
op 00 auto.lamp ? [CR]
would get the Data-Only response
0
You get only the answer and only in numeric form.
This is used mainly when a sequence of commands
is sent and the data is acted upon by the program.
For instance, the program might query each display
as to its lamp state, on or off, then send a Lamp On
command to just those displays that are off.
Keep in mind that displays only respond when they are individually
addressed.
Note