Owner`s manual

Serial Communications
60 VideoWall™/CineWall™ Installer/Integrator Manual
PRE
L
IMINAR
Y
Sample Operation Commands
Command Example (Note) Explanation
op 00 auto.position.disable = DISABLED [CR]
Disable the auto position feature
in display 00
op 00 auto.position.disable ? [CR]
Is the auto position feature
enabled or disabled in display 00?
op 00 brightness + [CR]
Increment the brightness in all dis-
plays with Group ID 0
op 00 curtain [CR]
Turn on (or off, if it is already on)
the curtain
op 00 center.point (red) ? [CR]
What is the value for the red pixel
at the center (sampling) point?
Note: The command line must always end with a carriage return character, noted in the examples
above as [CR]. The VideoWall/CineWall will not act on the command unless the last character is a
carriage return character (ascii hex value: 0D).
Sample Key Commands
Command Example (Note) Explanation (Note)
ky 00 menu [CR]
Press the MENU button on the
remote for display 00
ky 00 down [CR]
Press the down arrow on the
remote for display 00
ky 00 enter [CR]
Press the ENTER button on the
remote for display 00
Note: As you can see from Sample Key Commands sequence, if you are not looking at the screen,
you won’t know what you just did. You don’t know where the cursor was at the start.
Sample String Command
Command Example (Note) Explanation
st 00 revision ?<code>[CR]
What is the revision level of unit
00?