Owner`s manual

Installation
VideoWall™/CineWall™ Installer/Integrator Manual 43
PRE
L
IMINAR
Y
Adjusting Image PositionUse the Picture Position controls to center the picture on the screen. (This is NOT the
same as optical engine alignment.)
To adjust the image position:
1. Press MENU.
2. Select Size & Position from the Main Menu.
3. Select Picture Position from the Size & Position Menu.
4. Use the four arrow keys move the picture on the screen.
The numbers for Horizontal and Vertical Position refer to the number of pixels from sync to
the first displayed pixel. These numbers get smaller as the picture moves up and to the
left.
Picture Position
Use arrow keys to move image
Horizontal Position 234
Vertical Position 34
If you see a black edge on the screen and you can’t move the picture
to cover the black, you must adjust the optical engine position. Refer
to
Aligning the Image on page 33 to do this.
Note