Owner`s manual

Installation
VideoWall™/CineWall™ Installer/Integrator Manual 33
PRE
L
IMINAR
Y
3.7
Aligning the Image
The VideoWall/CineWall optical engine was perfectly adjusted when it left the factory.
However, vibration in transit may have moved it. Before performing any other image
adjustments, proceed as follows to confirm proper image alignment.
To align the optical engine:
1. Press MENU on the remote control and enter the Installer Menu passcode.
2. Select Advanced Options from the Main Menu.
3. Select Image Alignment from the Advanced Options menu.
4. Highlight Test Pattern in the Image
Alignment menu and choose Grid. This
pattern shows all the pixels in the optical
engine.
5. Highlight Adjust Corners in the Image Alignment menu and press ENTER or .
6. Use the , , and buttons to precisely position the upper-left corner of the
displayed grid pattern in the upper-left corner of the screen.
7. Press ENTER and repeat Step 6 for the other three corners.
8. Press PREV to save the corner position settings and exit the Adjust Corners menu.
9. Press PREV again to turn off the test pattern and exit the Image Alignment menu.