Owner`s manual

Installation
26 VideoWall™/CineWall™ Installer/Integrator Manual
PRE
L
IMINAR
Y
3.3
Connections to the
VideoWall/CineWall
Proceed as follows to connect the VideoWall/CineWall to your video sources, external
controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Route all cables through the cable
openings on the right side of the
VideoWall/CineWall chassis.
Connecting Source
Components to the
VideoWall/CineWall
Connect your video sources to the VideoWall/CineWall as shown and described in the
sections that follow.
HDMI/DVI Connections: Connect your digital video sources to the HDMI and DVI
inputs. See
Figure 3-2.
Figure 3-2. HDMI/DVI Source Connections
ROUTE CABLES
THROUGH THESE
OPENINGS
➤
Use the digital inputs whenever possible. This ensures the highest
video quality because the signal is carried in the digital domain
throughout the entire signal path, from source component output
into the VideoWall/CineWall.
Tip
DIGITAL DVI
DIGITAL HDMI
RS-232