Owner`s manual

Installation
22 VideoWall™/CineWall™ Installer/Integrator Manual
PRE
L
IMINAR
Y
3.2
Mounting the
VideoWall/CineWall
Chassis
This section provides detailed instructions for installing the VideoWall/CineWall chassis.
Install Top Flange and
Bottom Brackets on
Chassis Assembly
Install the Top Flange as shown in Figure 3-1. Then, install the Left and Right Bottom
Brackets (the ones with the latches on them) at the bottom corners of the chassis, and
install the Left Center and Right Center Bottom Brackets in the two intermediate locations.
Figure 3-1. Installing the Top Flange and Bottom Brackets
➤
The illustration below shows the Bottom Brackets for a CineWall
CW-95HD. The VideoWall VW-100HD brackets are slightly different
but the installation method is the same.
Note
Screw, Phillips Pan-Head,
0.164-32 x 0.25 x 0.25 (5x)
Top
Flange
Self-cliching
Nut (5x)
Screw, Phillips
Pan-Head,
1/4-20 x 0.5 x 0.5
(2 per bracket)
Bottom
Bracket,
Left
Bottom Brackets,
Left Center/
Right Center
Bottom
Bracket, Right