Owner`s manual

Introduction
8 VideoWall™/CineWall™ Installer/Integrator Manual
PRE
L
IMINAR
Y
Screen Assembly The Screen Assembly comprises all of the components associated with the screen which
is attached on the outer side of the installation wall. The Screen Assembly is packaged
separately from the Chassis Assembly, to facilitate unpacking and installation.
Southco-type latches at the bottom of the screen secure the screen in the closed
position.
A hinge system is provided at the top of the screen assembly that interfaces to the top
flange of the chassis assembly. This hinge allows the screen assembly to be “hooked”
from the top during initial installation. Two, small retaining brackets attach to the top rear
of the screen frame. These prevent the screen from “hopping” out of the hinge hook and
thus secure the screen.
Chassis Installation
Brackets
To reduce the overall depth of the chassis assembly for shipping, the installation brackets
that secure the chassis and screen to the wall are packaged separately. These brackets
are installed at the customer site right before installing the chassis assembly into the wall
opening:
Figure 1-1. Chassis Installation Brackets (Model CW-95HD shown)
➤
➤
Top Flange
Bottom Brackets (4)
Side Light
Block, Left
Bottom
Light
Blocks,
Left Side
(2)
Bottom Light
Blocks, Right
Side (2)
Side Light
Block,
Right