Owner`s manual

Introduction
VideoWall™/CineWall™ Installer/Integrator Manual 7
PRE
L
IMINAR
Y
Remote ControlThe VideoWall/CineWall remote control unit, shown below, allows you to perform the
following tasks:
1. ON
Press to turn the
VideoWall/CineWall on.
2. Source Select Buttons
Use these buttons to select a video
source (Analog, Digital DVI, Digital
HDMI, Component, S-Video or
Composite).
3. OFF
Press to turn the
VideoWall/CineWall off.
4. Aspect Ratio Selection Buttons
Use thee buttons to select an
aspect ratio (or “scale mode”)
directly.
5. MENU
Press this button to show or hide
the on-screen display (OSD) menus.
6. ENTER
Press to select a highlighted menu
item or confirm a changed setting.
7. PREV
Press this button to exit the current
menu and return to the previous
one.
8. UP
Use this button to move the menu
cursor up in the OSD.
9. ISF DAY
Press to recall the “ISF Day” memory slot.
10.RIGHT
Use this button to move the menu cursor to the right in the OSD.
11.LEFT
Use this button to move the menu cursor to the left in the OSD.
12.CUST 1-2
Press to recall the “Custom 1” or Custom 2” memory slot.
13.ISF NIGHT
Press to recall the “ISF Night” memory slot.
14.DOWN
Use this button to move the menu cursor down in the OSD.
ON
OFF
CPONENTANALOG
SVIDEO
PREVMENU ENTER
ISF DAY
ISF NIGHT CUST 1-2
HDMI DVI
CPOSITE
4:3 16:9 L BOX
CINEMA V CINE
V WIDE
1
3
5
7
14
9
2
4
6
8
11
10
13
12