Owner`s manual

Reference
110 VideoWall™/CineWall™ Installer/Integrator Manual
PRE
L
IMINAR
Y
Lamp Ballast: To see current lamp ballast status information, select Lamp Ballast from
the Diagnostics menu.
Hours: To see current system and lamp uptime information, or to reset the current lamp
hour counter, select
Hours from the Diagnostics menu.
• System Time is the number of hours the electronics module has received power.
• Running Time is the total number of hours any lamp has been on.
• Lamp is the total number of hours this lamp has been on (that is, if someone reset lamp
hours when they changed the lamp).
When you replace the projector lamp (refer to Lamp Replacement on page 51), you
should also reset the lamp hour counter. To do this, highlight Reset Lamp Hours in the
Hours menu and press ENTER.
Ballast
Voltage 89 V
Current -or- P/P Ratio 1.75
Temperature 59°C
Software Version 1109
Waveform ID -or- Status 13
Hours
System Time 00007:30
Running Time 00004:35
Lamp 00004:30
Reset Lamp Hours
1. Reset Lamp Hours does not affect the System Time or Running
Time counters.
2. Reset the Lamp Hours ONLY after you replace the lamp.
Otherwise, the reported Lamp usage will be inaccurate.
Note