Owner`s manual

Reference
94 VideoWall™/CineWall™ Installer/Integrator Manual
PRE
L
IMINAR
Y
Source: To select a source, highlight Source, press , select the source you want and
press ENTER.
Sync Type: This line indicates whether the source outputs separate horizontal and
vertical sync signals, a single, composite sync signal or a “sync-on-green” signal. In most
cases, the
Sync Type is Separate H&V.
Vertical Frequency/Horizontal Frequency/Pixel Frequency: These lines indicate the
Vertical Frequency, Horizontal Frequency and Pixel Frequency of the incoming signal.
Horizontal Resolution/Vertical Resolution: These lines indicate the Horizontal
Resolution and Vertical Resolution of the incoming signal.
Phase: This control adjusts the phase of the pixel sampling clock relative to the incoming
signal. Adjust the phase when an RGB or Component image still shows shimmer or
“noise.”
For best results, use a good test pattern such as a smooth gray consisting of a clear
pattern of black and white pixels, or a similar “half on, half off” graphic image. Adjust the
slidebar until the image stabilizes and each pixel is clearly defined. You may notice that
you can stabilize the image at more than one point. Use either setting in such cases.
Picture Menu – Digital or HDMI Sources
Picture
Source Digital
Vertical Frequency 60 Hz
Horizontal Frequency 43.36 kHz
Horizontal Resolution 1280
Vertical Resolution 768
Sharpness 7
Input Levels
Picture Menu – Component Sources
Picture
Source Component (YPbPr)
Vertical Frequency (frame locked) 60 Hz
Horizontal Frequency 43.36 kHz
Horizontal Resolution 1280
Vertical Resolution 720
Frequency 1344
Phase 22.5°
Sharpness 7
Input Levels