Specifications

Operation

D-113d Projection System Installation/Operation Manual 95

PRE

IMINAR

• HPD Toggle Rejection: Select HPD Toggle Rejection from the HDMI menu to specify

whether or not the DHD Controller ignores extraneous Hot Plug Detect (HPD) signal

state changes from a downstream HDMI device (third-party display or audio/video

receiver).

The default setting, Auto, enables HPD toggle rejection on the D-113d. Use the other

settings to troubleshoot compatibility issues or reduce the amount of time needed to

lock to an incoming signal.

Front Panel Brightness: Select Front Panel Brightness from the Service menu to adjust

the brightness of the front-panel LED and LCD status indicators.

• Logo LED: Select Logo LED from the Front Panel Brightness menu to adjust the

brightness of the large, illuminated logo on the left side of the display. The range is from

0 (off) to 31.

• Standby LED: Select Standby LED from the Front Panel Brightness menu to change

the behavior of the front-panel STANDBY indicator LED. When set to ON, the LED

lights amber when the system is in standby mode; otherwise, it is off. When set to OFF,

the LED is always off.

• LCD: Select LCD from the Front Panel Brightness menu to adjust the brightness of the

front-panel LCD. The range is from 0 (off) to 4.

Auto Power Off: Select Auto Power Off from the Service menu to have the D-113d turn

itself off after a period of inactivity (no source signal present).

•Enable: By default, Auto Power Off is disabled. To enable it, select Enable from the

Auto Power Off sub-menu and set it to On.

•Hours: The default time-out period is eight (8) hours; the range is from 1 to 24 hours.

During a firmware upgrade, this LED lights at full brightness

regardless of the Logo LED setting.

During a firmware upgrade, this LED lights at full brightness

regardless of the Standby LED setting.

Logo LED

LCD

Standby LED

Note