User's Manual

ManualsBrandsRuijie Networks ManualsComputers & Accessories1200M Dual Band Wi-Fi Range Extender

RG-REX12 Wi-Fi Range Extender

Scan to Download Reyee Router App

For technical support, please email:techsupport@ireyee.com

Technical support site: https://www.ireyee.com/support

Ethernet Port

Signal Status LED

System Status LED

Mesh/WPS Button

Range Extender *1 User Manual *1 Warranty Card *1

Package Contents：

Product Appearance

Note: Short press the Reyee to turn off the LED.

Set Up

Scenario 1: Connect to Reyee Device (Reyee Mesh)

1. Plug the extender halfway between your Reyee router and Wi-Fi dead

zone (within router signal range). Wait until turns solid green.

2. Click the Mesh button on your primary Reyee router (Not the extend-

er). Wait until turns solid white.

1. Plug the extender halfway between your router and Wi-Fi dead zone

(within router signal range). Wait until turns solid green. This might

take up to 1-2 minutes.

Scenario 2: Connect to Other Brand Router

2. Connect your computer or smartphone to SSID "@Reyee-sXXXX",

the instruction GUI launches automatically when you connect the SSID.

Follow the instructions to complete setup. If it does not auto-launch, visit

"http://10.44.77.254" to configure the extender.

3. The should turn solid white, indicating successful connection to the

router.

2. Press the WPS button on your router.

1. Plug the extender halfway between your router and Wi-Fi dead zone

(within router signal range). Wait until turns solid green.

Scenario 3: Connect via WPS

3. Within 2 minutes, press the WPS button on the extender. Wait until

turns solid white.

1. Plug the extender next to your modem. Wait until turns solid green.

2. Connect to the modem with an Ethernet cable. Wait until turns

solid green.

3. Connect your computer or smartphone to SSID "@Reyee-sXXXX", or

visit "http://10.44.77.254" to configure the extender.

Note: Connect a modem for uninterrupted connection via the 100Mbps

Ethernet port.

1. If the extender connects to a dual-band router, it will boost the 5G

Wi-Fi signal.

2. If you click the WPS button when the device is already in WPS

networking condition, it will not be paired again.

Scenario 4: Connect to the Modem

Note: If the signal lights only one bar, plug the extender closer to

your router.

Summary of content (2 pages)

PAGE 1
Product Appearance 1. If the extender connects to a dual-band router, it will boost the 5G Wi-Fi signal. 2. If you click the WPS button when the device is already in WPS networking condition, it will not be paired again. Scenario 4: Connect to the Modem 1. Plug the extender next to your modem. Wait until 2. Connect to the modem with an Ethernet cable. Wait until solid green.
PAGE 2
LED Descriptions 2. Via Web Browser: Visit http://10.44.77.254 to view or change extender settings. System Status LED Status Green Description Solid on The device works properly. / Connection success. Blinking The system is starting up / restoring factory settings. Solid on The device fails to access Wi-Fi network of the primary router. Blinking The device to accessing Wi-Fi network of the primary router. Solid on The network is unreachable.